Sentry CR105 Manual download pdf (Page 6)

U7698E Flame Detector

Part 334614E

E 2002 Nordson Corporation

Manual 34-49

Personal Safety

To prevent injury follow these instructions.

S Do not operate or service equipment unless you are qualified.

S Do not operate equipment unless safety guards, doors, or covers are

intact and automatic interlocks are operating properly. Do not bypass or

disarm any safety devices.

S Keep clear of moving equipment. Before adjusting or servicing any

moving equipment, shut off the power supply and wait until the

equipment comes to a complete stop. Lock out power and secure the

equipment to prevent unexpected movement.

S Relieve (bleed off) hydraulic and pneumatic pressure before adjusting or

servicing pressurized systems or components. Disconnect, lock out,

and tag switches before servicing electrical equipment.

S Obtain and read Material Safety Data Sheets (MSDS) for all materials

used. Follow the manufacturer’s instructions for safe handling and use

of materials, and use recommended personal protection devices.

S To prevent injury, be aware of less-obvious dangers in the workplace

that often cannot be completely eliminated, such as hot surfaces, sharp

edges, energized electrical circuits, and moving parts that cannot be

enclosed or otherwise guarded for practical reasons.

Fire Safety

To avoid a fire or explosion, follow these instructions.

S Do not smoke, weld, grind, or use open flames where flammable

materials are being used or stored.

S Provide adequate ventilation to prevent dangerous concentrations of

volatile materials or vapors. Refer to local codes or your material MSDS

for guidance.

S Do not disconnect live electrical circuits while working with flammable

materials. Shut off power at a disconnect switch first to prevent

sparking.

S Know where emergency stop buttons, shutoff valves, and fire

extinguishers are located. If a fire starts in a spray booth, immediately

shut off the spray system and exhaust fans.

S Clean, maintain, test, and repair equipment according to the instructions

in your equipment documentation.

S Use only replacement parts that are designed for use with original

equipment. Contact your Nordson representative for parts information

and advice.

1 2 3 4 5 6 7 8 9 10 11 ... 33 34

No comments

Sentry CR105 Manual Page 6